HP Jet Fusion 300 3D
Printer · 18 Probleemoplossingen
Probleemoplossing - HP Jet Fusion 300 3D
Veelvoorkomende problemen en oplossingen - ook zonder foutcode op het display.
Overige problemen 9
| Probleem | Oorzaak | Oplossing |
|---|---|---|
Verbinding & Smart Home 2
| Probleem | Oorzaak | Oplossing |
|---|---|---|
| Printer fails to connect to the network | Cable connection issues, network switch/hub configuration problems, or incorrect link settings | Check cable connections at both ends, try replacing cables with known working ones, switch to another network connector, manually configure link settings to match port configuration, or reset network parameters to factory settings |
| Printer is not connected to HP Cloud via HPSmartStream 3D Command Center | Network connectivity issue | Run diagnostics from the network troubleshooting guide or contact your support representative. Check your network connection using the site preparation guide |
Onderhoud & Verzorging 2
| Probleem | Oorzaak | Oplossing |
|---|---|---|
| Air intake filter door is open during printing | Air intake filter door not properly closed | Close the air intake filter door. If open during printing, the process will be cut automatically |
| Agent troubleshooting | Incorrect agent type, orientation, obstruction, or installation procedure | Check that the agent is designed for your printer, use the correct procedure to change agents through the front panel, ensure no obstruction in agent slot, verify correct agent type, and check proper orientation |
Prestaties & Werking 1
| Probleem | Oorzaak | Oplossing |
|---|---|---|
| Print failed during printing | Various printing issues | Printer will cancel the job immediately. Check front panel status and proceed with part retrieval if relevant. Allow printer to cool down before unlocking |
Stroomvoorziening & Elektronica 2
| Probleem | Oorzaak | Oplossing |
|---|---|---|
| Printer fails to start up and front panel is unresponsive | Startup status issue indicated by LEDs | Describe the status of the three LEDs beside the network connector to your support representative |
| Printer fails to power on and front panel is blank | Power issue indicated by LEDs | Describe the status of the three LEDs beside the power-cord panel to your support representative |
Temperatuurproblemen 2
| Probleem | Oorzaak | Oplossing |
|---|---|---|
| Cooling failed during cooling process | Cooling system malfunction | Check error notification on front panel and proceed with retrieval if relevant |
| Annealing failed during annealing process | Annealing system malfunction | Check error notification on front panel and proceed with retrieval if relevant |
Community-vragen
Stel een vraag
De foutcodes zijn afkomstig uit de officiële handleiding van de fabrikant.