Honeywell RTH6350

Overige problemen 8

Probleem	Oorzaak	Oplossing

3 meer tonen

Compressor 1

Probleem	Oorzaak	Oplossing
"Cool On" or "Heat On" flashes	Compressor safety function is active	Wait 5 minutes for the system to safely restart without compressor damage

Fan 1

Probleem	Oorzaak	Oplossing
Fan does not work when heating is needed	Function 3: Heating fan control not correctly set	Check Function 3: Heating fan control to ensure it matches your heating equipment (see page 16)

Installatie & Opstelling 3

Probleem	Oorzaak	Oplossing
Cannot change system setting to Cool	Function 1: System type not correctly set	Check Function 1: System type to ensure it matches your heating and cooling equipment (see page 14)
Heating and cooling equipment operate simultaneously or heating does not turn off	Bare wires touching or Function 1 not correctly set	Check Function 1: System type. Remove thermostat from wall panel and check that bare wires are not touching (see page 6)
Heating system operates in cooling mode	Function 1: System type not correctly set	Check Function 1: System type to ensure it matches your heating and cooling equipment (see page 14)

Stroomvoorziening & Elektronica 1

Probleem	Oorzaak	Oplossing
Display is blank	Empty or incorrectly placed batteries	Ensure fresh AA alkaline batteries are correctly installed (see page 7)

Temperatuurproblemen 3

Probleem	Oorzaak	Oplossing
Temperature settings do not change	Heating and cooling temperatures set outside acceptable ranges	Ensure heating and cooling temperatures are within acceptable ranges: Heat: 40°-90°F (4.5°-32°C). Cool: 50°-99°F (10°-37°C)
Heating or cooling system does not respond	System setting error, circuit breaker tripped, main switch off, or furnace door open	Set system to correct mode (Heat or Cool). Check that temperature is correctly set. Check circuit breaker. Ensure furnace door is closed. Wait 5 minutes for system response
Heat pump delivers cold air in heating mode or warm air in cooling mode	Function 2: Heat Pump Changeover Valve not correctly configured	Check Function 2: Heat Pump Changeover Valve to ensure it is correctly configured for your system (see page 15)