Vox EBB7226
Oven · 8 Probleemoplossingen
Probleemoplossing - Vox EBB7226
Veelvoorkomende problemen en oplossingen - ook zonder foutcode op het display.
Installatie & Opstelling 3
| Probleem | Oorzaak | Oplossing |
|---|---|---|
| Device damage during transport | Improper packaging or transport of the built-in appliance | Ensure the equipment is not damaged during transport. If damage occurs, do not use the appliance and immediately contact an authorized service representative. |
| Electrical or safety issues due to insufficient wiring | Incorrect or insufficient wiring during installation | Follow wiring and safety instructions carefully. The grounding wire must be connected via a screw with the earth symbol. The power cable must not come into contact with hot surfaces of the product. The grounding plug must be placed close to the appliance. Never use an extension cord. |
| Built-in appliance sustains damage due to poor placement | Insufficient distance between worktop and top of oven, or between worktop and control panel | When installing below a cooktop, the distance between the worktop and the top of the oven must be at least 50 cm. The distance between the worktop and the top of the control panel must be at least 25 cm. |
Onderhoud & Verzorging 2
| Probleem | Oorzaak | Oplossing |
|---|---|---|
| Unpleasant odor on first use | Insulation materials and heating elements release odor during initial operation | Before using the oven, run it empty at maximum temperature for 45 minutes. Ensure good ventilation in the room where the product is installed. |
| Damage to glass door | Use of hard abrasive cleaning products or sharp metal scrapers, or impact/collision on the glass | Do not use hard abrasive cleaning products or sharp metal scrapers to clean the glass door. Be careful when cleaning to prevent scratches. Avoid impact or collision on the glass with accessories. |
Prestaties & Werking 1
| Probleem | Oorzaak | Oplossing |
|---|---|---|
| Tray tilts and hot liquid leaks out | Tray is pulled out too far | Be careful when pulling trays out. Ensure hot liquid does not leak out. |
Stroomvoorziening & Elektronica 2
| Probleem | Oorzaak | Oplossing |
|---|---|---|
| Risk of electrical shock during lamp replacement | Device is not switched off before lamp is replaced | Ensure the device is switched off before replacing the lamp to prevent possible electrical shock. |
| Device does not work correctly due to wrong voltage | Mains voltage deviates from 220-240V~ | The device is designed for electrical connection 220-240V~. If the received power is different, immediately contact the authorized service center. |
Community-vragen
Stel een vraag
De foutcodes zijn afkomstig uit de officiële handleiding van de fabrikant.