Perlick HP24RO-4-5
Koelkast · 7 Probleemoplossingen
Probleemoplossing - Perlick HP24RO-4-5
Veelvoorkomende problemen en oplossingen - ook zonder foutcode op het display.
Onderhoud & Verzorging 5
| Probleem | Oorzaak | Oplossing |
|---|---|---|
| Clogged spray nozzles in the spray bundle | Mineral deposits or contamination in the spray nozzles | 1. Remove the spray bundle from the device. 2. Soak the spray bundle in the cleaning solution. 3. Gently clean the spray nozzles with a wire brush or suitable brush. 4. Rinse thoroughly with clean water. 5. Reinstall the spray bundle. |
| Slime buildup in the storage bin drain | Bacterial growth in the drain due to moisture and temperature | 1. Set the control switch to the 'OFF' position. 2. Remove all ice from the storage bin. 3. Mix a disinfection solution (1.25 fl.oz chlorine bleach per 2.5 gallons warm water). 4. Pour the solution slowly into the storage bin. 5. Allow the solution to drain. 6. Clean the inside of the storage bin with a neutral detergent. 7. Rinse thoroughly with clean water. 8. Set the control switch to the 'ICE' position. |
| Water stain or corrosion marks on stainless steel exterior | Oil, moisture, or dirt accumulation on the outer surface | 1. Wipe the outer surface with a clean, soft cloth. 2. Use a damp cloth with a neutral detergent to remove dirt or oil. 3. Dry with a clean cloth. |
| Condenser dirty or inefficient | Dust accumulation or dirt on the condenser fins | 1. Set the control switch to the 'OFF' position. 2. Unplug the device from the outlet. 3. Remove the front panel and louver. 4. Use a vacuum cleaner with a brush attachment to gently clean the condenser fins. 5. Do not use excessive force to prevent damage. 6. Replace the louver and front panel. 7. Plug in the device and set the switch to 'ICE'. |
| Cleaning solution remains in the device | Insufficient rinsing after cleaning | 1. Perform the complete rinse cycle as described: Set switch to 'ICE' for 2 minutes, then to 'WASH' for 5 minutes. 2. Repeat this process three times. 3. Verify that the suction hose drains completely. 4. Allow the device to run at least two cycles before using it to make ice again. |
Prestaties & Werking 1
| Probleem | Oorzaak | Oplossing |
|---|---|---|
| Ice cubes stuck on the evaporator | The harvest cycle was not performed | 1. Set the control switch to the 'OFF' position. 2. Wait 3 minutes. 3. Set the control switch to the 'ICE' position. 4. The harvest cycle starts automatically and removes the cubes from the evaporator. |
Waterproblemen 1
| Probleem | Oorzaak | Oplossing |
|---|---|---|
| Water leakage from loose connections | The suction hose or discharge hose is not connected correctly or the tabs are not fully locked | 1. Set the control switch to the 'OFF' position. 2. Verify that the suction hose tabs are fully interlocked. 3. Ensure that the discharge hose is securely connected to the spray bundle. 4. Lock all connections until they click. |
Community-vragen
Stel een vraag
De foutcodes zijn afkomstig uit de officiële handleiding van de fabrikant.
Bezoek de officiële Perlick website voor actuele informatie en ondersteuning.