Siemens DE2427628
Ketel & boiler · 1 Display-foutcodes · 17 Probleemoplossingen
Foutcodes - Siemens DE2427628
Deze codes worden op het display van uw apparaat weergegeven wanneer er een probleem wordt gedetecteerd.
| Foutcode | Beschrijving | Oplossing | Ernst |
|---|---|---|---|
| E .. KRITIEK | Apparaat heeft een storing | Het apparaat door een vakman laten controleren | KRITIEK |
Probleemoplossing - Siemens DE2427628
Veelvoorkomende problemen en oplossingen - ook zonder foutcode op het display.
Overige problemen 9
| Probleem | Oorzaak | Oplossing |
|---|---|---|
| The display shows 00.0°C | The air detection in the device detects air in the water and switches off the heating capacity for a short time | The instantaneous water heater automatically returns to operation after a few seconds |
Display & Weergave 1
| Probleem | Oorzaak | Oplossing |
|---|---|---|
| No display despite functioning circuit breaker in household installation | The device has a fault | Have the device checked by a technician |
Stroomvoorziening & Elektronica 1
| Probleem | Oorzaak | Oplossing |
|---|---|---|
| No display | The circuit breaker in the household installation has been activated | Check the circuit breaker in the household installation |
Temperatuurproblemen 4
| Probleem | Oorzaak | Oplossing |
|---|---|---|
| The set high water temperature is not reached | The instantaneous water heater is connected to a thermostatic mixing valve | Set the temperature on the instantaneous water heater to 60 °C |
| The water does not get warm | The supply temperature has dropped | Reduce the amount of water from the tap until the desired hot water temperature is reached |
| The outlet temperature is higher than the set temperature | The inlet temperature in the water heater is higher than the set temperature (e.g. due to preheated water from the solar energy system) | The thermostatic pre-mixer in the household installation must be set to a correspondingly lower temperature |
| A symbol lights up on the display | The power limit has been reached | Reduce the amount of water from the tap or set the temperature of the device lower |
Waterproblemen 2
| Probleem | Oorzaak | Oplossing |
|---|---|---|
| Insufficient water flow | The strainer in the water tap or shower head is clogged | Remove the strainer and clean or descale it |
| Insufficient water flow despite cleaning the strainer in the water tap or shower head | A strainer in the device is clogged | Have the device cleaned by a technician |
Community-vragen
Stel een vraag
De foutcodes zijn afkomstig uit de officiële handleiding van de fabrikant.